hypro centrifugal pump repair|hypro pump parts catalog : wholesalers Jun 29, 2010 · Part 1 of a 3 part series...• Tools required for working on a hydraulically driven centrifugal pump• Remove the front housing, impeller, mechanical seal, an...
How does a Self-Priming Centrifugal Pump Work? A self-priming centrifugal pump has two phases of operation: priming mode and pumping mode. In its priming mode, the pump essentially acts as a liquid-ring pump. The rotating impeller generates a vacuum at the impeller’s ‘eye’ which draws air into the pump from the suction line.
{plog:ftitle_list}
Operating anywhere between 760 litres/min to 19,000 liters/min, split case centrifugal pumps offer high performance with more simplified maintenance. Approved, Reliable and Designed for .
Hypro centrifugal pumps are widely used in various industries for their efficiency and reliability. However, like any other equipment, these pumps may require repair and maintenance from time to time to ensure optimal performance. In this article, we will discuss the repair process for a hypro centrifugal pump, including the tools required and the steps involved.
Hypro has created a comprehensive video featuring a service technician who guides you
Tools Required for Working on a Hydraulically Driven Centrifugal Pump
Before starting the repair process, it is important to have the necessary tools on hand. Some of the tools required for working on a hydraulically driven centrifugal pump include:
- Wrench set
- Screwdriver set
- Pliers
- Hammer
- Gasket scraper
- O-ring pick
- Bearing puller
- Hydraulic press
- Cleaning solvent
- Lubricant
Having these tools readily available will help facilitate the repair process and ensure that the job is done efficiently and effectively.
Removing the Front Housing, Impeller, Mechanical Seal, and More
The first step in repairing a hypro centrifugal pump is to remove the front housing, impeller, mechanical seal, and other components. This process may vary slightly depending on the specific model of the pump, but the general steps are as follows:
1. Disconnect the pump from the power source and drain any remaining fluid from the system.
2. Remove the bolts or screws securing the front housing to the pump casing.
3. Carefully lift off the front housing to expose the impeller and mechanical seal.
4. Use a wrench to loosen the impeller nut and carefully remove the impeller from the shaft.
5. Inspect the impeller for any signs of damage or wear and replace if necessary.
6. Remove the mechanical seal by gently prying it out of its housing.
7. Inspect the mechanical seal for any signs of leakage or wear and replace if needed.
Part 1 of a 3 part series...• Tools required for working on a hydraulically driven centrifugal pump• Remove the front housing, impeller, mechanical seal, an...
About this item . √ Circulation pump is non-self-priming pump. This pump is centrifugal pump, it can't vent the air automatically, so it must be operated by submersible installation.Fit for .
hypro centrifugal pump repair|hypro pump parts catalog