hypro centrifugal pump repair|hypro pump catalog pdf : online sales Jun 29, 2010 · Part 1 of a 3 part series...• Tools required for working on a hydraulically driven centrifugal pump• Remove the front housing, impeller, mechanical seal, an...
HARDALLOY SUBMERSIBLE PUMPS S-FP Designed for severe duty submersible applications with abrasive, corrosive slurries. Power plants. . submersible low solids content applications requiring high heads. Power plants. Seawater sand slurry. Lime slurry. CAPACITIES 60 to 550 gpm 15 to 120 m /hr HEADS 20 to 165 ft 6 to 50 m WEIGHT 950 lb 430 kg K125 .
{plog:ftitle_list}
A screw pump is a type of positive displacement pump that uses one or more screws to move fluids or solids along the screw axis. It is known for its ability to handle viscous fluids and maintain a steady, pulsation-free flow.
Hypro centrifugal pumps are widely used in various industries for their efficiency and reliability. However, like any other equipment, these pumps may require repair and maintenance from time to time to ensure optimal performance. In this article, we will discuss the repair process for a hypro centrifugal pump, including the tools required and the steps involved.
Hypro has created a comprehensive video featuring a service technician who guides you
Tools Required for Working on a Hydraulically Driven Centrifugal Pump
Before starting the repair process, it is important to have the necessary tools on hand. Some of the tools required for working on a hydraulically driven centrifugal pump include:
- Wrench set
- Screwdriver set
- Pliers
- Hammer
- Gasket scraper
- O-ring pick
- Bearing puller
- Hydraulic press
- Cleaning solvent
- Lubricant
Having these tools readily available will help facilitate the repair process and ensure that the job is done efficiently and effectively.
Removing the Front Housing, Impeller, Mechanical Seal, and More
The first step in repairing a hypro centrifugal pump is to remove the front housing, impeller, mechanical seal, and other components. This process may vary slightly depending on the specific model of the pump, but the general steps are as follows:
1. Disconnect the pump from the power source and drain any remaining fluid from the system.
2. Remove the bolts or screws securing the front housing to the pump casing.
3. Carefully lift off the front housing to expose the impeller and mechanical seal.
4. Use a wrench to loosen the impeller nut and carefully remove the impeller from the shaft.
5. Inspect the impeller for any signs of damage or wear and replace if necessary.
6. Remove the mechanical seal by gently prying it out of its housing.
7. Inspect the mechanical seal for any signs of leakage or wear and replace if needed.
Part 1 of a 3 part series...• Tools required for working on a hydraulically driven centrifugal pump• Remove the front housing, impeller, mechanical seal, an...
Designed to handle the toughest services in a broad spectrum of solids handling and .
hypro centrifugal pump repair|hypro pump catalog pdf